![]() ![]() A 50-foot (15.25 m) cable is included with the D-Command Main Unit. I did, I connected BM out12&13 to Xmon Linein1&2 with DB25XLRF which is connected to Stereo Inputs of Xmon.īut its mono on icon Dcommand and I only have audio on R-speaker. XMON back panel XMON Monitoring System Connection D-Command connects to XMON with a single 15-pin XMON cable. When you have finished the Makefile, type make to make the two programs xmond and xmonui. The console has a SUM button as well so that you could listen to Pro Tools on MAIN (input green button) AND have your Mac on Stereo 2 go beep whenever you hit the wrong buttons.ĪLT is for Alternate speakers, so you can have a pair of GArgantuan Extreme Woofly Buggers as your MAIN speakers (big yellow button), Middling Size Speakers as ALT, and Teeny Weeny little TV type speakers as MINI speakers, enabling you to choose the Output monitoring for 3 different sets of speakers. Even if PT is not running, you can still quickly switch to say your Mac sound card or watch and listen to a DVD. Below are the details: System Setup: PPC G5 Dual 2.3GHz Mac OS X 10.5.5 Pro tools HD 7.4.2cs4 D-Command Firmware 7.4.2. Then you can quickly switch inputs to the Xmon from the console. 1 01-10-2010, 09:46 PM sandika Member Join Date: Nov 2009 Posts: 5 XMON problem Hi All, We have a customer who recently had a XMON problem. Any other signals, like the BM output would go into Stereo in 1 Xmon, your Mac could go into Stereo in 2 Xmon, something completely different like a DVD/CD could go into Stereo in 3 Xmon. You want to completley bypass the Omni monitor section and go direct out (eg 1 and 2 Omni out) into the Main ins on the Xmon for general PT use. Is there any software that I need to install for the XMON We have been using the the ICON without the XMON for a few years. D-Command Specifications D-Command Console Width 8 Fader Console: 32.3' / 82.04 cm 24 Fader Console: 55.6' / 141.22 cm D-Command Main Unit Weight: 58 lbs / 26.4 kg AC: 100 240 VAC, 50 60 Hz. Do not modify the syntax of boot loader parameters without extreme need or. The D-Command uses the Xmon and will give you greater monitoring flexibilty than the Omni. Module parameters can be specified in two ways: via the kernel command line. It has a command-line syntax similar to strace in its default mode, you just prefix ' xtruss ' to the same command line you would have run anyway and its output format is also more like strace, putting requests and responses on the same line of output. ![]() Sounds as though you're currently using the Omni for monitoring. So this page presents xtruss, my own contribution to the field of X protocol loggers. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |